Reassembly

1. Replace recoil rod and spring into recoil rod hole in frame.

2 Insert front of recoil spring into spring hole at front of slide.

3 Pull slide back over the barrel, then down and back.

4. Pull slide back slightly, approximately 1/4", so bolt can be inserted into top of slide.

5L Drive bolt back into slide until retaining pin holes in side and bolt are aligned. (Use a soft face hammer to avoid damaging top of bolt or slide).

6, Replace firing pin and spring, push forward and let hammer down to hold in place, make sure RECESS in firing pin is lined up looking through retaining pin hole.

7, Replace bolt retaining pin.

8, Check for proper functioning before loading.

Was this article helpful?

0 -1

Post a comment