Rifle Mm Ml Rifle Mm Ma And Bipod Rifle M

ThU manual is current aa of 15 May 1 65 IL Description and data 1-4 8,4 CHajto DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE INSTRUCTIONS Section L Repair parte, special tools, end II. Troubleshooting m. Inepections IV. Removal and installation of major groupe and aesembllee 2-8 0 V. Depot maintenance instructions Section 1. General maintenance II. Maintenance of magasine assembly and bend guard III. Maintenance of firing IV. Maintenance of stock with butt plate aeaembly < M14 only)...

Chapter Repair Instructions

Complete disassembly of a unit is not always necessary in order to make a required repair or replacement. Exercise good judgment to keep disassembly and assembly operation to a minimum. Tool sets provided for maintenance of the weapon are listed in appendix B. a. Replace all parts that may cause weapon to malfunction. 1 Replace spring pins and cotter pins, if needed and available. If screws, nuts, washers, and retainers are damaged beyond repair, they will be replaced. 2 All springs should...

Refer to table S

7274761 Gage

Check trigger pull with trigger pull measuring fixture 7273758. When using the 4Y2 pound weights minimum the trigger should not release the hammer. When using the 7Vfe pound weights maximum , the trigger should release the hammer fig. 3-2 and table S-S . Worn Jug on trigyer, worn hooks on hammer, worn or damaged car or weak hammer spring. Bur or irregular machined grooves on lugs of trigger or sear, damaged hammer spring, obstruction in the hammer spring housing, or a damaged hammer spring...

M14 Front Sight

M14 Assault Rifle Gas Piston Tolerance

A, INSERTING ALIGNMENT s TOOL IN FLASH SUPPRESSOR ' AND BARREL IORE. TabU 3-11. Procedure lor checking alignment of flash tuppresior using alignment tool 7799705. A, INSERTING ALIGNMENT s TOOL IN FLASH SUPPRESSOR ' AND BARREL IORE. C. FLASH SUPPRESSOR ALIGNED WITH BARREL BORE. C. FLASH SUPPRESSOR ALIGNED WITH BARREL BORE. TabU 3-11. Procedure lor checking alignment of flash tuppresior using alignment tool 7799705. A INSERTING BARREL PILOT . IN MUZZLE END Of BARREL A INSERTING BARREL PILOT . IN...

BRefer to TM P for repair part

Rifle Military

Table 3-1SL Guide to Maintenance Functions Table 3-1SL Guide to Maintenance Functions Grind any nicked or burred edge on bladt Replace If broktru Note. Grinding or r condition Ing of bayonet-knlis blades will be restricted to direct support, general support maintenance hope or depot rebuild installations. Tighten or replace looee or missing rivets If latching lever spring, latching lever, spring well or boodf are damaged or unserviceabls, repair or replace ae oecweary. If pine are worn or...

Stdlen I General

M14 Steel Bipod

These instructions re In accordance with the maintenance allocation chart and are published for the use of direct and general support and depot maintenance personnel maintaining the 7,62-MM Rifle, M14, M14A1 and Rifle Bipod M2. a. General DA Forme and proceduree used for equipment maintenance will be only thoee prescribed in TM 88-760, Army Equipment Record Proceduree. b. Recommendations for Maintenance Manual Improvements. Report of errors, omissions, and recommendations for improving this...

General

Hi section provides specific instructions for guidance during inspection by direct and general support personnel of materiel in the hands of troops in the field, in direct and general support shops, and in alerted units scheduled for oversea duty. Inspections are made for the purpose of a. Determining serviceability, ft. Recognizing conditions that would cause failure. c. Assuring proper maintenance at prescribed levels. d. Determining the ability of a unit to accomplish its maintenance and...