a. Column 1, Group Number. Column 1 lists functional group code numbers, the purpose of which is to identify maintenance significant components, assemblies, subassemblies, and modules with the next higher a assembly. End item group number shall be "OO."
b. Column 2, Component Assembly. Column 2 contains the names of components. Assemblies, subassemblies, and modules forwhich maintenance is authorized.
c. Column 3, Maintenance Function. Column 3 lists the functions to be performed on the it em listed in Column 21. (for detailes explanation of these functions, see paragraph B-2.)
d. Column 4, Maintenance Level. Column 4 specifies, by the list ing of a work time figure in the appropriate subcolumn(s), the level of maintenance. If the number of complexity of the t asks within the listed maintenance function vary at different maintenance levels, appropriate work time figures will be shown for each level. The work time figure represents the average time required to restore an item (assembly, subassembly, component, module, end it4m, or system) or a serviceable condition under typicalfield operating conditions. This time includes preparation time (including any necessary disassembly assembly time), troubleshooting fault location time, and quality assurance quality control time in addition to the time required to perform the specific tasks identified for the maintenance functions authorized i the maintenance allocation chart. The symbol designations for the varies maintenance levels are as follows:
C Operator or Crew
O Unit Maintenance
F Direct Support Maintenance
H General Support Maintenance
L Specialized Repair Activity (SRA)6
D Depot Maintenance e. Column 5, Tools and Equipment. Column 5 specifies, by code, those common tool sets (not individual tools) and special tools., TMDE, and support equipment required to perform the designated function.
f. Column 6, Remarks. This column shall, when applicable, contain a lett4er code, in alphabetic order, which shall be keyed to the remarks contained in Section IV.
6This maintenance level is not included in Section II, column (4) of the Maintenance Allocation Chart. To identify functions to this level of maintenance, enter a work time figure in the "H" column of section II, column (4), and use an associated reference code in the Remarks column (6). Key the c ode to Section IV . Remarks, and explain the SRA complete repair application there. The explanatory remarks)s) shall reference the specific Repair Parts and Special Tools List (RPSTL) TM which contains additional SRA criteria and the authorized spare/repair parts.
Was this article helpful?