MA and M Only Note

For the purpose of the following check "SLOW" is defined as 1/4 to 1/2 the normal rate of trigger release.

4. Hold trigger to the rear, charge weapon, and release the trigger with a slow, smooth motion, without hesitations or stops, until the trigger is fully forward; an audible click should be heard. Hammer should not fall.

5. Repeat the SEMI position test five times. The weapon must not malfunction during any of these five tests. If the weapon malfunctions during any of these five tests, evacuate rifle to support maintenance for repair.

6. Place selector lever in BURST position. Charge weapon and pull trigger. Hammer should fall.

7. Hold trigger to the rear, pull charging handle assembly to rear and release three times. Release trigger. Hammer should not fall. The burst disconnector should have held the hammer to the rear while the trigger was in the pulled position.

8. Pull trigger. Hammer should fall. This should be the first round of a three round burst.

9. With hammer in forward position, attempt to place the selector lever in the SAFE position. If selector lever can be placed on SAFE, evacuate the weapon to support maintenance.

Was this article helpful?

0 0
Plyometrics Fitness Adrenaline

Plyometrics Fitness Adrenaline

It Seems Incredible That You Can Get Your Ideal Body By Jumping. This Book Is One Of The Most Valuable Resources For The Fitness Adrenaline.

Get My Free Ebook

Post a comment