Rifle Only

Small amounts of side-to-side, up-and-down or rotational movement of the buttstock assembly is acceptable.

(1) Cracks visible around the buttplate mounting holes while screws are mounted

SH - Cracks are visible around mounting holes when installed on rifle.

(2) Cracks or separations around the door assembly are visible when the door assembly is closed

SH - Cracks are visible when door assembly is closed.

(3) If buttplate is cracked in excess of 0.25 in (O 64 cm) in length and extends through the buttplate (14). see pg. 2-64 for repair

SH - If cracked in excess of 0 25 in. extends thru buttplate

(4) The buttplate (14) should not be removed other than for repair or replacement of parts at which time a new self-locking screw, NSN 530501-147-8585, must be used.

Item No.

Interval

Item to be Checked or Serviced

Procedure

Not Fully Mission Capable if:

6

Quarterly (cont)

Lower receiver and buttstock assembly (serviceability check) (cont)

NOTE

If a weapons lower receiver is missing one third or more of its exterior protective finish, resulting in an unprotected/light reflecting surface, it is candidate for overhaul. This missing finish will be considered a shortcoming.

This shortcoming requires action to obtain a replacement weapon. Once a replacement has been received, evacuate the original weapon to depot for overhaul.

If scratched or worn shiny in spots, repair in the same manner as outlined for upper receiver (see item 4 above).

7

Quarterly

M16A2 Rifle

Assemble as in TM 9-1005-319-10 (operator's manual).

Check sling for damage. If damaged, replace.

Check for improperly assembled, broken, missing, or damaged parts. Check over all general appearance. Replace parts as required and authorize evacuation to support maintenance for repair.

Change 4 2-19

Item No.

Item to be Checked or Serviced

ENANCE CHECKS AND SERVICES FOR M16A2 Procedure

Not Fully Mission Capable if:

8

Quarterly

Annual DS safety and serviceability inspection and gaging

Check to ensure annual DS safety and serviceability inspection and gaging has been done and that the next gaging and inspection is scheduled. If annual gaging has not been performed within the last year, notify support maintenance.

Annual gaging has not been performed.

Section IV. TROUBLESHOOTING

Section IV. TROUBLESHOOTING

Was this article helpful?

0 0
Plyometrics Fitness Adrenaline

Plyometrics Fitness Adrenaline

It Seems Incredible That You Can Get Your Ideal Body By Jumping. This Book Is One Of The Most Valuable Resources For The Fitness Adrenaline.

Get My Free Ebook


Post a comment