Info

MP5 FUNCTION CHECK / OPERATOR INSPECTION A. A Function Check should be performed anytime the weapon is reassembled. This quick check indicates whether or not the weapon has been properly assembled and/or assembled with all components. A properly executed Function Check can also reveal many of the more obvious malfunctions that could occur between the interactive components of the weapon.

1. Clear the weapon.

2. Place the cocking handle and bolt group in the forward position.

3. With the weapon on "Safe", pull the trigger. Hammer should not fall.

4. Place the weapon on "Semi-automatic". Pull the trigger and hold the trigger bacKt Hammer gh<?vi<3 fall.

5. stj;i holding the trigger recock the weapon. Release the trigger. Listen for the "click" of the trigger and sear resetting. Pull the trigger. Hammer should fall.

6. Place the weapon on "Burst", if applicable. Recock the weapon. Pull the trigger and hold the trigger fracKr Hammer should fall.

Still_holding the trigger back, recock the weapon.

Release the trigger. You should not hear the hammer fall. (The hammer should already be forward.)

8. Place the weapon on "Fully-automatic", if applicable. Recock the weapon. Pull the trigger and hold the trigger back. Hammer should fall.

Still_holding the trigger back, recock the weapon.

Release the trigger. You should not hear the hammer fall. (Again, the hammer should already be forward.)

The Function Check is now complete.

Was this article helpful?

0 0

Post a comment