Sig Pistol

Serial number:

Date

Number of Rounds Fired

Cumulative Total of Rounds Tit**

Users Name

Maintenance

Performed/

Remarks

Weapon Type

Serial Number:

Date

Cumulative Total of Rounds Fired

Users Name

Maintenance Performed/

fiemqrKg

Weapon Type serial Number:

Pate

Number of Rounds Fired

Cumulative Total of Rounds £Ued

Users Name

Maintenance

Performed/

RemarXs

I. Barrel

4. Slide

5. Front sight

6. Rear sight

15. Frame

16. Take-down lever

18. Slide catch lever

20. Trigger

29. Hammer

40. Decocking lever

43. Magazine catch

51. Magazine

3. Thumb down the take-down lever to the vertical position.

1. Unload and check the chamber both visually and physically. Check again!

2. Lock the slide to the rear by inserting an EMPTY magazine and pulling the slide to the rear until slide is locked back by the slide catch lever, or simply pull the slide to the rear and push the slide catch lever up into the arresting notch in the slide.

3. Thumb down the take-down lever to the vertical position.

5. Pull the slide slightly to the rear to disengage the slide catch lever, then move the slide forward and off the frame, allowing the recoil spring to gradually release tension.

4. Remove the empty magazine.

5. Pull the slide slightly to the rear to disengage the slide catch lever, then move the slide forward and off the frame, allowing the recoil spring to gradually release tension.

6. Remove the recoil spring and guide by grasping the end of the guide and pulling it away from the barrel lug, gradually releasing the remaining recoil spring tension.

7. Remove the barrel by gripping the large lug on the bottom of the barrel and lifting it up and away from the slide.

MAGAZINE - DISASSEMBLY AND ASSEMBLY Disassembling the Magazine - Sequence of Operations

1. Invert the magazine.

2. Depress the magazine insert with a suitable tool through the opening in the floor plate.

3. Slide the floor plate off the magazine tube, ensuring magazine spring tension is gradually released.

NOTE: The magazine spring is under great pressure - keep work operation away from the face.

4. Remove the magazine spring and magazine follower from the magazine tube. Assembling the Magazine - Sequence of Operations

1. Place the magazine follower on the magazine spring (raised end of spring under the front of the magazine follower).

2. Hold magazine tube vertically and insert the magazine follower and magazine spring.

3. Invert the magazine, attach magazine insert to the end of the magazine spring, compress the magazine spring fully into the magazine tube and install the floor plate.

NOTE: Be sure that the insert locks into the floorplate opening.

Was this article helpful?

0 0

Post a comment