Diagram Of The Beretta 92f

Downward oressure must be maintained on h the lanyard loop to overcome the main spring pressure. A 1/8 inch punch should be used to aline the lanyard loop spring pin hole with the hole in the receiver. This will allow proper atinement of the lanyard loop spring pin during installation.

Ensure hammer is in the down or forward position.

Eibar 380 DiagramBeretta Diagrams

WRONG

Beretta Diagrams

RIGHT

WRONG

RIGHT

9. Install the lanyard loop (9) into the main spring cavity 18} with the cutout forward. Rotate the receiver (1) and rest the lanyard loop {9) on a soft support. Compress the main spring |7| by pushing down on the receiver (1). At the same time, insert a 1/8 inch punch to aline the lanyard loop spring pin (101 with the lanyard loop pin hole (11). Drive the lanyard loop spring pin {10) in until slightly below flush.

Beretta DiagramsBeretta 92f Trigger Spring Position

REASSEMBLY (cont) \

10. Install the trigger (1) into the trigger cavity (2j. Aline the lower hole 13) of the trigger with the hole in the receiver. Insert the trigger pin (4) into the left side of the receiver (5) until it holds the trigger in position.

11. Insert the trigger bar post (1} through the oval siot (2| into the trigger bar post hole of the trigger (3). At the same time, insert the trigger bar lug (4) into the trigger bar lug cutout (5) of the receiver.

Beretta Pistol Diagram

| 3-11. MAINTENANCE OF RECEIVER ASSEMBLY (cont) | | HE ASSEMBLY Icon!) |

Browning 9mm

Was this article helpful?

+4 0

Post a comment