Sight Model Adjustments

WINDAGE: To move point of impact to the right, loosen the screw on the right side of the sight. Then tighten the screw on the left side of the sight. To move point of impact to the left, loosen the screw on the left side of the sight and tighten the screw on the right side. This is a process of trial and error. Make small adjustments then check the point of impact.

VERTICAL: Vertical adjustment is controlled by two screws loated on top of the sight. To raise the point of impact, loosen the front screw and then tighten the rear screw. To lower the point of impact, loosen the rear screw and then tighten the front screw. Vertial adjustment is also a process of trial and error.

0 0

Responses

  • lester
    How to order browning a bolt shotgun sans sights.?
    3 years ago

Post a comment