Before Performing Any Adjustments Al Wa Ys Make Certain There Is No Shell In The Chamber

1 Loosen the two stock adjustment set screws on the right side of the removable cheek piece and remove the cheek piece by lifting upward (See Figure 17). This exposes the Cast On and Cast Off adjustment mechanism. The cheek piece comes set from the factor}' with cast in the center position.

2 Loosen both of the stock adjustment stud screws located in the top of the stock adjustment studs using the larger (3mm) alien wrench provided (See Figure 18). It takes about 1/4" turn to loosen them adequately.

3 Slide each stud equally in the desired direction. Etch mark indicates 1/16".

4 Move the studs to the right for Cast Off.

WARNING:

Was this article helpful?

0 0

Post a comment