Sight Adjustment

HORIZONTAL:

1 To move the point of impact to the right: loosen the coin slotted screw, located on the right side of the sight by turning in a counterclockwise direction and tighten the screw on the left side by turning in a clockwise direction (Figure 9). This causes the rear sight to move to the right.

2 To move the point of impact to the left: simply reverse this procedure.

VERTICAL:

Vertical adjustment of the sight is controlled by the screw located on top and to the rear of the sight. To raise the point of impact, turn the screw in a clockwise direction until the sight has been raised the

FIGURE 9

SjMJiBitii

Horizontal Sight Adjustment needed amount (Figure 10). To lower the point of impact, turn the screw counter-clockwise.

Was this article helpful?

0 0

Post a comment