Headspace And Timing

Headspace is the distance between the face of the bolt and the base of the cartridge case, fully seated in the chamber. Timing is the adjustment of the gun so that firing takes place when the recoiling parts are in the correct position for firing. Because the cartridge is held by the T-slot of the bolt, headspace with the MG is measured as the distance between the rear of the barrel and the face of the bolt. This occurs when the recoiling parts are forward and there is positive contact between the breech lock recess in the bolt and the lock in the barrel extensions. Periodic calibration checks should be made of the gauge by direct support personnel at least annually.

Firing a weapon that has improperly set headspace and timing could result in damage to the machine gun, or injury to the gunner. Damage may also occur in the trunnion block, base of the barrel, or face of the bolt. This warning applies whether the gun is firing service ammunition or M1E1 blanks. (The weapon has improper early timing when two rounds are fired - and firing stops.)

a. Gauges. The headspace and timing gauge consists of a headspace gauge and two timing gauges (Figure 3-16). These gauges provide an accurate means of checking the adjustment of headspace and timing.

NOTE: The headspace and timing gauge should be kept with the gun at all times.

b. Headspace. Check and set headspace before firing, after assembling the gun, and after replacing the barrel or receiver group. Use the following procedures to set headspace.

(1) Raise the cover all the way up. Grasp the retracting slide handle (Figure 3-17). Using the retracting slide handle, retract the bolt until the barrel-locking-spring lug is centered in the 3/8-inch hole on the right side of the receiver (Figure 3-18).

Was this article helpful?

+2 0
Perfect Tattoo

Perfect Tattoo

Ever Wanted to Get a Tattoo? Here is a Priceless Guide on How to Choose the Perfect Tattoo! Do you ever find yourself admiring the artistic work of another person’s tattoo? Do you wish you had the nerve to get one of your own but just aren’t sure you know enough about them to take that final step?

Get My Free Ebook


  • cipriano
    Why is timing important m2 .50 machine gun?
    11 months ago
  • Miniya
    What is improper timing as it relates to firearms?
    8 months ago
  • howard
    How to time a M1 .50 cal machine gun?
    6 months ago
  • renee heine
    How does a headspace/timing gauge work for a 50 caliber machine gun?
    3 months ago

Post a comment