Figure G Anpeqa with accessories

(1) TPIAL assembly with safety block.

(5) Cable switch, 12-inch, membrane.

(6) Operator's manual.

(8) Strap, retention.

(9) Cable Switch, 20-inch, button.

(10) Bracket Adapter.

(11) Training extender (Army only).

(12) M4/M16A2 bracket assembly.

G-10. OPERATION

This paragraph describes how to operate the AN/PEQ-2A, to include battery installation, safety block installation, the button switch, the cable switch, the mode switch, and boresight adjusters.

a. Battery Installation (Figure G-11). Unscrew the battery caps and install two AA batteries. Orient the batteries as indicated by the markings on the AN/PEQ-2A body.

b. Safety Block Installation (Figure G-12). The safety block installed in the training mode (blue side up) prevents the operator from accessing the non-eye safe modes (AIM HI, DUAL LO/HI, DUAL HI/HI). A .050 hex head Allen wrench is needed to unscrew the block from the body and reinstall it in the tactical mode (black side up).

Figure G-11. AN/PEQ-2A battery installation.

Figure G-12. Safety block installation.

c. Mode Selector. The mode selector is used to set the mode in which the AN/PEQ-2A operates when the cable-switch button or the push button is depressed. The mode selector has six positions (Table G-2).

KNOB POSITION

OPERATION

OFF

The AN/PEQ-2A does not operate.

AIM LO

The aiming beam operates at low power.

DUAL LO

The aiming beam operates at low power and the illuminating beam operates at low power.

AIM HI

The aiming beam operates at high power.

DUAL LO/HI

The aiming beam operates at low power and the illuminating beam operates at full power.

DUAL HI/HI

The aiming beam operates at high power and the illuminating beam operates at full power.

Table G-2. Mode selector positions.

d. Button Switch (Figure G-13, page G-18). The button switch is used when the AN/PEQ-2A is hand held. Pressing the button switch operates the AN/PEQ-2A in the operational mode set by the mode selector. When the button is released, the AN/PEQ-2A turns off. A green LED is incorporated into the body of the AN/PEQ-2A to indicate that the AN/PEQ-2A is ON. Whenever the AN/PEQ-2A is activated, the green LED lights and stays lit until the unit is turned OFF. If continuous operation of the AN/PEQ-2A is desired, pressing the button switch twice in rapid succession latches the AN/PEQ-2A to ON. The AN/PEQ-2A remains on until the push button is pressed a third time.

Was this article helpful?

0 0
Knife Throwing Techniques of the Ninja

Knife Throwing Techniques of the Ninja

Knife Throwing Techniques of the Ninja. span stylecolor: 000000Do you want to learn the art of throwing knives? Ever wondered how it is done to perfection every time? Well here is your chance. This book contains well over 50 pages of detailed information and illustrations all about the art of knife throwing. This intriguing book focuses on the ninja's techniques and training. This is a must for all martial artists and anyone wanting to learn the knife throwing techniques of the ninja.span

Get My Free Ebook


Post a comment