When buttstock is off do not pull the cocking handle to the rear without first removing the drive spring assembly

d. Remove the Trigger Housing Assembly. Depress spring pin and remove. You may need to use the back of the back plate of the buttstock to tap on the spring pin, then remove pin with fingers. All pins go from right to left (Figure 3-15, page 3-14). Rotate the rear of the trigger-housing group assembly down, disengage the holding notch at the front of the assembly from its recess on the bottom of the receiver, and remove the assembly from the receiver (Figure 3-16, page 3-14).

Figure 3-15. Trigger spring pin.
Figure 3-16. Removal of trigger housing.

e. Remove the Cover Assembly. (A) Close cover. Depress spring pin and remove. You may need to use the back of the back plate of the buttstock to tap on the spring pin. (B) Then remove pin with fingers. All pins go from right to left. (C) Depress cover latches, lift upwards and remove cover assembly. (D) Remove feed tray (Figure 3-17, page 3-16).

Crew Served Machine Guns
Figure 3-17. Removal of cover, feed tray, and spring pin.

f. Remove the Barrel Assembly. (A) Make sure that the barrel-carrying handle is to the right side. Depress the barrel-locking latch located on the left side of the receiver where the barrel joins the receiver and hold. (B) Grasp the barrel carrying handle and rotate the carrying handle to the upright position (without pulling up on the barrel release). (C) Then push forward and pull up, separating the barrel from the receiver (Figure 3-18).

Crew Served Machine Guns
Figure 3-18. Removal of barrel.

g. Disassemble the Barrel Assembly. (A) Hold the barrel at the point where the gas system attaches to it. (B) Grasp and rotate the gas collar clockwise until it releases from the gas plug. Remove the collar from the gas plug. (C) Slide the gas regulator plug from front to rear, removing it from the gas hole bushing. (D) Remove heat shield. Lift the rear of heat shield assembly off the barrel, then pry one of the front metal tabs out of hole on gas hole bushing, rotate the heat shield towards the other metal tab, and remove heat shield from the barrel. This completes the general disassembly (Figure 3-19, page 3-18).

Figure 3-19. Gas regulator and collar.

Was this article helpful?

0 0
Knife Throwing Techniques of the Ninja

Knife Throwing Techniques of the Ninja

Knife Throwing Techniques of the Ninja. span stylecolor: 000000Do you want to learn the art of throwing knives? Ever wondered how it is done to perfection every time? Well here is your chance. This book contains well over 50 pages of detailed information and illustrations all about the art of knife throwing. This intriguing book focuses on the ninja's techniques and training. This is a must for all martial artists and anyone wanting to learn the knife throwing techniques of the ninja.span

Get My Free Ebook


Post a comment