Mounting The At To Your Bench

Place your AT 500 on the edge of a sturdy bench or table where you plan to mount it. Give yourself about 12 inches of work space on each side of the machine to allow room for components.

Using the machine itself as a template, mark and drill four 1/4" holes in your bench and bolt your AT 500 securely to it. (Figure 3)

Figure 3 - Using the reloader as a template to mark your bench.

Avoid using wood or lag screws to mount your reloader to the bench. These types of screws can loosen over time.

Figure 3 - Using the reloader as a template to mark your bench.

Avoid using wood or lag screws to mount your reloader to the bench. These types of screws can loosen over time.

Was this article helpful?

0 0

Post a comment