Fig

3. Lower the platform.

4. FIG 117 Back the seating stem all the way out of the seating die. Now screw the seating stem back into the seating die two full turns FIG 118.

5. Place a bullet on the case mouth and raise the platform - then lower the platform just enough to inspect the bullet without indexing the shellplate.

a. If the bullet is not pushed down far enough - go to step 6.

b. If the bullet is pushed down too far:

b.1. Pull the bullet from the case using a Dillon bullet puller.

b.2. Back the seating stem out by turning it counter clockwise and try again.

6. Screw the seating stem down 1/2 turn at a time FIG 118.

Was this article helpful?

0 0

Post a comment