Fig

3. Raise the platform and continue to screw the die down until it touches the cartridge FIG 69.

4. Lower the platform and give the die an 1/8 turn down, again raise the platform.

5. Lower the platform halfway and inspect the cartridge. If the bell is still present, or the desired amount of crimp has not been achieved, give the die a 1/8 turn down and try again. Continue making small adjustments to your crimp die until the desired amount of crimp has been achieved.

6. Once the adjustment is complete, place the case back into Station 5 and raise the platform. Using a 1-1/8" wrench to turn the lockring and a 7/8" wrench to hold the die body, snug the lockring.

Was this article helpful?

0 0

Post a comment