Fig

2. Raise the platform and screw the powder check die into Station 3 and raise the platform. There should be a 1/8 to 1/4 inch space between the shellplate and the bottom of the die FIG 106.

3. Run the lockring down. Using a 11/8" wrench snug the lockring.

platform causes the buzzer housing to rock into the side of the die collar FIG 111.

3. Run the lockring down. Using a 11/8" wrench snug the lockring.

platform causes the buzzer housing to rock into the side of the die collar FIG 111.

Was this article helpful?

0 0

Post a comment