Fig

9. Run the lockring down until it contacts the toolhead. Using a 1 1/8" wrench to turn the lockring and a 3/4" wrench to hold the die body, snug the lockring FIG 82.

D. Station 1 - The decapping assembly FIG 78:

Dillon decapping assemblies are made with replaceable decap pins. One extra pin is included with each sizing die. To replace a bent or broken pin, simply:

Note:

3. Screw the decapping assembly back into the sizing die.

The decapping assembly must be removed when loading primed

Note:

Note:

2. Unscrew the decapping pin (see arrow FIG 84), and replace it with a new one.

3. Screw the decapping assembly back into the sizing die.

The decapping assembly can be removed from the sizing die without affecting the adjustment of the sizing die or sizing operation.

The decapping assembly must be removed when loading primed

E. Station 2 - Installation of powder measure assembly FIG 85:

1. Using a 5/32" Allen wrench, loosen the two collar clamp screws and remove the powder die FIG 86 & 87.

Was this article helpful?

0 0

Post a comment