Fig

C. Station 1 - Installation and adjustment of the siz-ing/decapping die FIG 78:

Warning: Never attempt to de-prime a live primer, an explosion may result causing serious injury or even death.

Note: Whenever sizing a bottle-necked case you must lubricate the case first, otherwise you will stick the case inside the sizing die. For more information refer to the section "Lubricating Your Brass" (page 11).

1. Raise the platform, by lowering the handle all the way.

2. Install the sizing die by screwing it into Station 1 FIG 79. Continue to screw the die down until the mouth of the die is about the thickness of a dime away from the shellplate. Lower the platform by raising the handle to its upright position.

Was this article helpful?

0 0

Post a comment