Station 2 Locator Adjustment On Dillon 650

Note: The objective here is that - at the point the case becomes fully inserted into shellplate (with the handle against its full aft stop) - the camming pin is still in contact with the case insert slide cam - or at least within a 1/16" of the case insert slide cam (see arrow FIG 193).

5. Once properly adjusted, tighten the lock nut.

Step 17) Adjusting the Station 2

Locator Tab (see note just above Step 16):

The adjustment of the Station 2 locator tab is best accomplished with the toolhead removed.

1. Place a case in Station 2.

Dillion Xl650 Inmages

Was this article helpful?

+1 0

Post a comment