Fig

5. a) If the large powder bar is currently installed - remove the large powder bar.

b) If the small powder bar is currently installed - remove both the small powder bar and small powder bar spacer FIG 198. Note: The purpose of the spacer is simply to make up for the room allowed for the large powder bar.

6. a) Installation of the large powder bar - slide the large powder bar into the powder measure body. b) Installation of the small powder bar - slide both the small powder bar and small powder bar spacer into the powder measure body FIG 199. Note: The groove along the edge of the spacer (see arrow FIG 199) is to be installed face down. The hole in the spacer is to be aligned with the hole in the top of the powder measure body FIG 199.

Was this article helpful?

0 0

Post a comment