Fig

Note: After raising the handle, insure that you push the handle against its full aft stop FIG 28. This will insure that the case is fully inserted into Station 1.

Note: Also, when priming, pushing the handle against its full aft stop, FIG 28, will insure that the primer is fully seated.

6. Again, raise the platform. The case is now sized. If the case has a spent primer, it will be deprimed. Leave the platform in the raised position with the case fully inserted in the die. This will ensure that the die remains in alignment when tightening the lockring.

Was this article helpful?

0 0

Post a comment