Info

OL data

flST

OL data

C - Compressed Powder Charge

PR - Primer

BBL - Barrel

COL - Cartridge Overall Length

REF - Reformed

Bullets

The loads shown in this section should be followed just as they are printed. These loads are like recipes. The closer they are followed, the better the resultant load.

NEVER Exceed the

W arnings Loads Listed in

This Publication

For all brands of powders use only the components shown. If the reloader makes any changes in components or gets new lot numbers, he should begin again with the starting loads and work up to maximum cautiously.

The loads shown here are at maximum. Reduce them by 10% and work up to the load that works best for you.NEVER EXCEED THE LISTED LOADS.

H110 Loads should not be reduced more than 3%. Reduce H110 Loads 3% and work up from there. H110 if reduced too much will cause inconsistent ignition. In some cases it will lodge a bullet in the barrel, causing a hazardous situation (Barrel Obstruction). This may cause severe personal injury or death to users or bystanders.

DO NOT REDUCE H110 LOADS BY MORE THAN 3%.

40 S&W WARNING: This data is intended for use in firearms with barrels which fully support the cartridge in the chamber. Use of this data in firearms which do not fully support the cartridge may result in bulged cases, ruptured cases, case head separation, or other condition which may result in damage to the firearm and/or result in injury or death of the shooter and/or bystanders.

Brands

Was this article helpful?

0 0

Post a comment