Info

PROCEDURE:

1. Screw threaded cap onto pipe.

2. Place propeilant and igniter in paper or rag and tie package with string so contents will not fall out.

Igniter Leads

Propeilant and igniter

Direction of shot

Trip Device (Electrical Contact)

3. Insert packaged propeilant and igniter into pipe until package rests against threaded cap leaving firing leads extending from open end of pipe.

long and the same diameter as pipe. Insert rag wadding against packaged propeilant igniter. With caution, pack tightly using stick.

5. Insert stones and/or scrap metal into pipe.

Connecting Battery

Wires Section II

Was this article helpful?

0 0

Post a comment