This Weapon Can Also Be Made Using The Explosive And Fuse Below

Explos i ve:

Mix three (3) parts Potassium chlorate and one (I) part granulated sugar. Confine in a container (in this case the claymore mine) and use time fuse to set it off. Time Fuse:

Boil equal parts of potassium chloratc and granulated sugar in water. Dip cotton string in the solution and let dry. Buring rate is approx. sixty (60) seconds per foot. Test some to rctake sure I

This weapon can a I so, be used on the side of a truck or tractor. This was done In Vietnam and was found to be highly effective in ambush situations where the enemy was at close quarters to the vehicle being attacked.

Make a steel box approx. 6" deep and 12 by 12" on the sides. Just sides S bottom, no top. Solidly attach the box to the side of a vehicle with bolts or weld it in place. Hake sure rt Is attached to something solid - remember that back blastl Hake up 2 sand bags, one 6x12 and the other about 10 x 12. Set the small bag in the bottom of the box and the larger bag into the back of the box. (The open 'end of the box should point outwards* from the vehicle). Now set the claymore into the box so that it is sitting on top of the small bag and against the large bag. Securely fasten the mine Into the box with wtre or what ever is handy so it won't fall out as you drive down the road.

A switch set into the dash is the easiest way to set this placement off. Wire a lead from the battery thru a breaker or a fuse to the switches and them to the •claymores.

Steel Balls

Plastic Sealer

Steel Balls

Plastic Sealer

Casing*^ Black Powder

Colored wires D Joined to form one curcuit

STEP k - CONTROL BOX

1. Glue the rubber or plastic strip to the other 1-1/2" x V1 strip of wood. This will be the bottom of the box. When assembling, the plastic or rubber will be facing up.

2. Screw the hinges to one of the

2-1/2" x V1 pieces of wood and attach the other side of the hinge to the side of one of the 2-1/2" x 1-1/2" pieces of wood.

3- Drill a 1/16" hole in the bottom of the other 2-1/2" x 1-1/2" piece of wood, which will be the left side of the box, and a 1/8" hole in the top right hand corner of the other 2-1/2" x V piece of wood, which will be the back wall of the box.

k. Using nails, screws or glue, assemble the box. There will be no top to It.

Was this article helpful?

0 0

Post a comment