Set of assembly tools for PS pistol

This set of assembly tools is used for maintenance and repair of the P9S pistol (see diagram 5). Each individual tool should be used as itemized below.

Item Tool designation_Application

1

Screwdriver 2 mm x 180

for set screw (10) in the slide, Fig. 13

2

Screwdriver 5.5 mm x 120

for lens head countersunk screws (3 and 4) of the grip (exploded diagram 3);

for lens head countersunk screw (11) in the receiver, Fig. 27

3

Screwdriver 4 mm x 100

for countersunk screw (29) in the receiver, Fig. 19 and 47

4

Assembly mandrel for safety catch

for pressing-in of firing pin (17) and safety catch (3) into the slide. Fig. 10

5

Assembly mandrel 016x200

for bolt head carrier (7) in the slide, Fig. 15

6

Pincers

for catch spring (3), Fig. 30, insert piece (9), Fig. 32 and indicator pin (21) in the receiver, Fig. 43

7

Assembly mandrel 0 5x100

for bolt head carrier (7), Fig. 11

8

Backing-out punch 0 2.8

for cylindrical pin (16) in the bolt head carrier, Fig. 12; for cylindrical pin (6) in the receiver, Fig. 18,22,24 and 25; for hammer axle (23), Fig. 21

9

Backing-out punch 0 1.8

for clamping sleeve (13), Fig. 14

10

Assembly pin 0 3.85

for hammer axle (20), Fig. 45; for indicator pin (21) and disconnector (22) in the receiver

11

Assembly pin 0 2.85

for trigger (4), trigger spring (5), Fig. 34; barrel clamp (7), Fig. 35; safety latch (16), catch lever (17) and magazine catch (25) in the receiver

12

Supporting surface

for resting on it slide and receiver whilst carrying out the various disassembly and reassembly operations

13

Hammer

according to requirement

14 Cleaning kit, for cleaning the pistol according to these instructions cal. 7.62 - 9 mm

14 Cleaning kit, for cleaning the pistol according to these instructions cal. 7.62 - 9 mm

Was this article helpful?

0 0

Post a comment