Caution

Ring assembly must be supported over a clean, dry area.

1 Remove sleeve bushing (1) from upper revolving ring (2).

2 Remove pintle lock cap (3), two S chain hooks (4), and weldless chain (5).

3 Remove cotter pin (6), ring spacer (7), helical compression spring (8), manual control handle (9), and headless shoulder pin (10) from upper revolving ring (2). Discard cotter pin.

4 Remove two cotter pins (11) from pintle lock handle (12) and remove pintle lock handle from upper revolving ring (2). Discard cotter pins.

5 Remove machine screw (13) and lockwasher (14) from three seal ring segments (15, 16, and 17), and remove three seal ring segments from outer seal ring (18). Discard lockwasher.

6 If damaged, remove two headed straight pins (19) and separate seal ring segment (15), seal ring segment (16), and seal ring segment (17).

7 Remove 24 machine screws (20), 24 lockwashers (21), and outer seal ring (18) from upper revolving ring (2). Discard lockwashers.

8 Remove mechanical felt (22) from outer seal ring (18). Discard mechanical felt.

9 Remove mechanical felt (23) from outer seal ring (24). Discard mechanical felt.

M122 Tripod

Remove 22 machine screws (25), 22 lockwashers (26), and seal retainer ring (27) trom lower revolving ring (28). Discard lockwashers.

Remove mechanical felt (29) from outer seal ring (24). Discard mechanical felt.

Remove two self-locking nuts (30), two flat washers (31), two socket head capscrews (32), and ring brake (33) from upper revolving ring (2). Discard self-locking nuts.

Remove two socket head capscrews (34) and brake lining clamp (35) from lower revolving ring (28).

Remove shoe brake assembly (36) from upper revolving ring (2).

CAUTION

Lower revolving ring, separator segments, and roller bearings may fall out when self-locking nuts and socket head capscrews are removed.

Remove 22 self-locking nuts (37) and 22 socket head capscrews (38). Discard self-locking nuts.

16 Carefully remove lower revolving ring (28) from outer seal ring (24).

17 Carefully lift upper revolving ring (2) from outer seal ring (24).

18 If damaged, remove 16 separator segments (39) and 96 roller bearings (40) from outer seal ring (24)

INSPECTION/REPAIR

1 Inspect for broken, damaged, or missing parts.

2 If outer seal ring is broken or damaged, repair is by replacement of next higher assembly.

3 If upper revolving ring is broken or damaged, repair is by replacement of next higher assembly.

4 Ring brake is a repairable assembly. Refer to paragraph 8-5.

5 Repair is by replacement of authorized parts (appx C).

Glock Exploded View

Was this article helpful?

0 0

Post a comment