Assembly Continued

7. INSTALL RECOIL SPRING COMPRESSION TOOL ONTO RECOIL MECHANISM.

a. Prepare recoil spring compression tool (13) by holding center section (14) and turn outer section (15) clockwise until six threads can be seen in cutout (16) of tool.

b. Place the recoil spring compression tool (13) over top of the recoil mechanism (7).

c. Screw entire recoil spring compression tool (13) clockwise onto threads of recoil mechanism (7) until seated.

Feeder Handle M242

8. REPOSITION RECOIL MECHANISM AND RECOIL SPRING COMPRESSION TOOL IN VISE.

a. Remove recoil mechanism (7) and recoil spring compression tool (13) from vise.

b. Place center section (14) of recoil spring compression tool (13) in vise.

c. Install handles (17) into outer section (15) of recoil spring compression tool (13).

Was this article helpful?

0 0

Post a comment