25mm Wiring Harness

Do not overtighten screw or wiring harness will split. 3. CONNECT WIRING HARNESS CONNECTOR J2.

a. Place automatic gun feeder (1) with feeder handle (12) on bottom.

INSTALLATION - Continued b. Connect wiring harness connector J2 (13) to cable connector (14).

c. Install screw (15) on wiring harness connector J2 (13). Torque screw to 36 in.-oz ± 4 in.-oz (0.254 N-m ± 0.028 N-m).

Bevfitchett M242 25mm

4. INSTALL ACCESS COVER.

a. Position automatic gun feeder (1) with feeder handle (12) down and remove two capscrews (16) temporarily installed in index drive cover assembly (17).

b. Align access cover (18) with automatic gun feeder (1) so wiring harness fits into the cutout (19).

M242 25mm Bevfitchett

c. Loosely install seven capscrews (16) into access cover (18).

d. Position automatic gun feeder (1) on side as shown.

INSTALLATION - Continued e. Trip automatic gun feeder (1) out of sear position by pressing rod (20) in and turning worm shaft nut (21) counterclockwise until the arrow points between the two "E"s in the word "FEED".

f. Tighten two opposing capscrews (16).

Suzuki Forenza Timing Marks

g. Rotate worm shaft nut (21) counterclockwise until automatic gun feeder (1) locks in sear position. Trip automatic gun feeder (1) out of sear position by pressing in rod (20) and turning worm shaft nut (21) counterclockwise through three complete feed cycles. Feel for binding as worm shaft nut (21) is turned.

h. If no binding is found, proceed to step k.

i. If binding occurs, loosen two capscrews (16) 1/4 to 1/2 turn and slightly shift the position of the access cover (18).

j. Trip automatic gun feeder (1) out of sear position and turn the worm shaft nut (21)

counterclockwise through one feed cycle and stop in sear position. Repeat steps e through h as required until the binding has either been removed or reduced as much as possible.

INSTALLATION - Continued k. Position automatic gun feeder (1) with feeder handle (12) down.

M242 Cycles

Was this article helpful?

0 0

Post a comment