Caution

Use caution in removal of electrical connector so as not to damage pins or connector casing. Gently use a screwdriver to pry on rubber part of electrical connector if needed to remove connector from bracket assembly bushing.

c. Pull electrical connector (2) out of bracket assembly bushing (6) and push electrical connector (2) through hole (7) in automatic gun feeder (1).

2. POSITION AUTOMATIC GUN FEEDER.

Place automatic gun feeder (1) on a clean, flat surface with feeder handle (8) in down position.

3. REMOVE ACCESS COVER.

a. Remove seven capscrews (9) from access cover (10).

b. Pull access cover (10) from automatic gun feeder (1).

c. Temporarily reinstall two capscrews, (9) into index drive cover assembly (11).

REMOVAL - Continued

Was this article helpful?

0 0

Post a comment