Caution

Timing marks must remain aligned through the installation of the rear plate assembly.

15. INSTALL SLIDING SLEEVE CLUTCHES, CLUTCH YOKE ASSEMBLY, AND SHOULDERED SHAFTS.

a. Place clutch yoke assembly (34) on work surface with actuator pin (35) towards you.

b. Hold lower sliding sleeve clutch (36) in your left hand, with clutch dogs (37) going in the same direction as your thumb.

c. Hold upper sliding sleeve clutch (38) in your right hand, with clutch dogs (39) going in the same direction as your thumb.

d. Install lower and upper sliding sleeve clutches (36) and (38) into clutch yoke assembly (34).

ASSEMBLY - Continued

Was this article helpful?

0 0

Post a comment