Caution

Place feeder handle in down (locked) position to protect electrical connector on bottom of automatic gun feeder.

REMOVAL

REMOVE FEED SHAFT STOP ASSEMBLIES.

Remove two feed shaft stop assemblies (1) from feeder housing assembly (2).

INSPECTION

INSPECT FEED SHAFT STOP ASSEMBLIES.

Visually inspect feed shaft stop assemblies (1) for dirt, broken springs, and galls. If any damage is found, refer to WP 0044 00.

INSTALLATION

1. INSTALL FEED SHAFT STOP ASSEMBLIES.

a. Position feeder housing assembly (1) as shown.

b. Install two feed shaft stop assemblies (2) into feeder housing drive assembly (1).

c. Tighten both feed shaft stop assemblies (2).

2. INSTALL AUTOMATIC GUN FEEDER (WP 0026 00).

END OF WORK PACKAGE

UNIT

M242 25-MM AUTOMATIC GUN (NSN 1005-01-086-1400) M242 25-MM ENHANCED AUTOMATIC GUN (NSN 1005-01-454-0396)

FEED SHAFT STOP ASSEMBLIES DISASSEMBLY/ASSEMBLY DISASSEMBLY, CLEANING, INSPECTION, LUBRICATION, ASSEMBLY

INITIAL SETUP:

Tools and Special Tools

Artillery and turret mechanic's tool kit

Personnel Required

(item 41, WP 0085 00) Goggles (item 19, WP 0085 00) Rubber gloves (item 18, WP 0085 00) Turret mechanic's supplemental tool kit

Equipment Conditions

WP 0043 00 Feed shaft stop assemblies removed

Materials/Parts

Acid brush (item 4, WP 0116 00)

Special Environmental Conditions

Well-ventilated area required when using dry cleaning solvent.

Dry cleaning solvent (item 27, WP 0116 00) Grease (item 11, WP 0116 00) Spring pin (12524618-2)

Was this article helpful?

0 0

Post a comment