Caution

Do not drop lockwire pieces into gun. Wire can get between moving parts and damage gun.

6. DISCONNECT WIRING HARNESS CONNECTOR P2.

a. Remove lockwire from two captive screws (16).

b. Loosen two captive screws (16).

c. Remove wiring harness connector P2 (17) from electrical feed select solenoid (18).

M242 25mm Feed Select Solenoid

INSPECTION

INSPECT ELECTRICAL FEED SELECT SOLENOID BODY.

Visually inspect feed select solenoid body connector for burnt, bent, or broken connector pins. If any of these conditions are found, replace feed select solenoid body.

INSTALLATION

Was this article helpful?

0 0

Post a comment