Caution

Do not clean bearing in solvent or allow solvent to run into bearing. Solvent will remain in bearing and dissolve lubricant, resulting in excessive wear or damage to bearing.

M242 25mm Worm Shaft Cleaning
1df0768

CLEANING - Continued

2. CLEAN FEED SHAFT SECTION COMPONENTS.

Using brush and solvent, clean rear plate assembly (8), spur gears (9) and (10), shouldered shafts (11) and (12), yoke actuator (13), fork shaft assembly (14), clutch yoke assembly (15), gear clutch assembly (16), worm wheel gear (17), and lower and upper sliding sleeve clutches (18).

3. CLEAN INDEX DRIVE ASSEMBLY COMPONENTS.

a. Using brush and solvent, clean index drive parts (19) except rotor stub (20).

b. Using clean rag, wipe rotor stub (20).

c. Allow parts to air dry.

INSPECTION

Was this article helpful?

0 0

Post a comment