Info

2. REMOVE LINK SHIELD.

a. Pry up on link shield (3) until it springs away from lower right stepped spacer (4).

b. Lift link shield (3) about 1 in. (25.4 mm). Push link shield (3) toward feeder drive assembly (5) until small curved portion of link shield (3) is clear of feeder standoff (6) and is under rear upper link stripper (7).

c. Lift and rotate link shield (3) to the right. Remove link shield (3) from feeder drive assembly (5).

Dodge 4x4 Front Axle Vacuum Hose

INSPECTION

INSPECT LINK SHIELD.

Visually inspect link shield for bends and cracks. If either of these conditions are found, replace link shield.

1. INSTALL LINK SHIELD.

a. Position link shield (1) with small curved portion of shield down and toward feeder drive assembly (2). Place upper right corner of shield over feeder standoff (3) and under forward upper link stripper (4).

b. Lower the left side of the link shield (1) until shield is resting on feeder standoff (3).

c. Pull link shield (1) out and down until small curved portion of shield is firmly seated on feeder standoff (3).

d. Push down on lower center portion of link shield (1) with thumb until large curve of shield snaps down over lower right stepped spacer (5).

INSTALLATION

Was this article helpful?

0 0

Post a comment