Inspection

1. NON-RIBBED BARREL ASSEMBLY ONLY: INSPECT BARREL ASSEMBLY.

a. Inspect barrel assembly (1) for cracks or bends. If either of these conditions are found, replace complete barrel assembly.

b. Inspect barrel assembly (1) for loose muzzle brake (2). Slight looseness is acceptable, but muzzle brake shall not rotate more than 1/4 in. (0.64 cm). Muzzle brakes failing this criteria must be reinstalled (WP 0024 00).

c. Inspect barrel assembly (1) for damaged or missing cotter pin (3). Replace missing or damaged cotter pin (WP 0024 00).

" \ NON-RIBBED TYPE BARREL ASSEMBLY

" \ NON-RIBBED TYPE BARREL ASSEMBLY

Pump Airgun Schematic

1df0190

2. RIBBED TYPE AND CHROME BARREL ASSEMBLIES ONLY: INSPECT BARREL ASSEMBLY.

Was this article helpful?

0 0

Post a comment