Note

Slide yoke actuator can fall off until feed select solenoid is installed. k. Slide yoke actuator (47) in place on feeder housing assembly (2).

ASSEMBLY - Continued

16. INSTALL SPUR GEARS.

a. Verify the timing marks on the small gear of the gear clutch assembly (30) face the upper shouldered shaft (45).

b. Place upper feed shaft spur gear (48) (with two single timing marks, offset 90 degrees) over shouldered shaft (45). Place one timing mark (49) between the two timing marks (50) and (51) on the gear clutch assembly (30). Place the other timing mark (52) towards the lower shouldered shaft c. Place lower feed shaft spur gear (53) over lower shouldered shaft (42) so that the single timing mark (52) on the upper feed shaft spur gear (48) is between the two timing marks (54) and (55) on the lower feed shaft spur gear (53).

d. Make sure both spur gears (48) and (53) are fully seated.

e. Check all timing marks for correct alignment.

1df0817

1df0817

17. INSTALL REAR PLATE ASSEMBLY.

a. Apply a light coat of grease and install two new preformed packings (56) in feed shaft flanged bushings (57).

b. Apply a light coat of grease to two new preformed packings (58) and install new preformed packings into slots in cartridge stops (59).

c. Insert cartridge stops (59), with pointed end out, into holes (60) and (61).

ASSEMBLY - Continued d. Align rear plate assembly (62) with feeder housing assembly (2) and gear shafts.

e. Push rear plate assembly (62) firmly toward feeder housing assembly (2).

Feed Shaft Stops M242

18. INSTALL CAPSCREWS.

a. Install and torque two capscrews (63) to 160 in.-lb ± 10 in.-lb (18.08 N-m ± 1.13 N-m).

b. Stand feeder housing assembly (2) on end with feeder handle (64) on top.

c. Install and torque four capscrews (65) to 80 in.-lb ± 5 in-lb (9.04 N-m ± 0.57 N-m).

d. Turn feeder housing assembly (2) as shown.

e. Install and torque two capscrews (66) to 80 in.-lb ± 5 in-lb (9.04 N-m ± 0.57 N-m).

Was this article helpful?

0 0

Post a comment