Note

Do not force handle. If excessive force is required, check alignment of feeder on receiver.

5. LOCK AUTOMATIC GUN FEEDER.

Press down on feeder handle latch (9) and rotate feeder handle (10) downward until locked.

M242 FeederM242 Feeder

TESTING

1. INSTALL HAND CRANK ON AUTOMATIC GUN FEEDER.

b. Rotate hand crank (1) clockwise to lock it into hub (2).

2. SELECT LOWER FEED.

Pull out feed select knob (3) on electrical feed select solenoid (4).

3. RELEASE GUN FROM SEAR POSITION.

Press sear release link (5) and rotate hand crank clockwise one-half turn. Release sear release link (5).

1x1 Technic Brick Lego Dimensions
/

1df0233

TESTING - Continued

4. ROTATE HAND CRANK CLOCKWISE AND OBSERVE THE FOLLOWING ACTIONS.

a. Lower feed sprocket assembly (6) rotates and feeder assembly rotor (7) rotates 1/3 turn.

b. Bolt and carrier assembly (8) moves in a forward direction.

c. Lower feed shaft stop assembly (9) moves out.

d. Automatic gun feeder (10) stops and locks in MISFIRE position.

e. If any of the above actions do not occur, perform automatic gun feeder manual cycle check (WP 0007 00).

Feeder Receiver Weapon
link bridge removed for clarity

5. CYCLE AUTOMATIC GUN FEEDER OUT OF MISFIRE POSITION.

Press sear release link (5) and rotate hand crank (1) clockwise one-half turn. Release sear release link

6. ROTATE HAND CRANK CLOCKWISE AND OBSERVE THE FOLLOWING ACTIONS.

a. Lower feed sprocket assembly (6) rotates.

b. Bolt and carrier assembly (8) moves in rearward direction.

c. Lower feed shaft stop assembly (9) snaps into locked position.

d. Automatic gun feeder (10) stops and locks in SEAR position.

e. If any of the above actions do not occur, perform automatic gun feeder manual cycle check (WP 0007 00).

9mm Desert Eagle Exploded View

TESTING - Continued

7. SELECT UPPER FEED.

Push feed select knob (3) into electrical feed select solenoid (4).

Was this article helpful?

0 0

Post a comment