Feed Select Soilenoid 25mm

Slide yoke actuator may be attached to feed select solenoid when removed. If it is, reinstall slide yoke actuator.

5. REMOVE ELECTRICAL FEED SELECT SOLENOID.

a. Place automatic gun feeder (1) against work surface with electrical feed select solenoid (15) positioned as shown.

b. Remove six capscrews (16).

c. Lift electrical feed select solenoid (15) from automatic gun feeder (1).

M242 Feeder

INSPECTION

1. INSPECT ELECTRICAL FEED SELECT SOLENOID.

a. Visually check electrical feed select solenoid (1) for cracks, bends, and broken parts. If any of these conditions are found, replace electrical feed select solenoid.

b. On electrical feed select solenoid (1), push and pull red select knob (2) to verify that it locks into detent positions and that plunger moves in and out. If it doesn't, replace electrical feed select solenoid.

M242 Feed Select Solenoid

c. Visually inspect wiring harness for frayed cable or broken connector pins. If any of these conditions are found, replace electrical feed select solenoid.

INSPECTION - Continued

2. INSPECT AUTOMATIC GUN FEEDER HOUSING.

Visually inspect feeder housing for loose or damaged screw threaded inserts. If either of these conditions are found, send feeder housing to Direct Support Maintenance for repair.

INSTALLATION

Was this article helpful?

0 0

Post a comment