Note

The following data will be legibly marked by brush-, roll-, or spray-stencil on the same container area with black enamel or stencil ink. If stencil marking is used, letters and numbers must be 3/8 to 1 in. (0.95 to 2.54 cm) high, and the stencil must be sharply cut.

a. NSN 1005-01-105-5191 for Standard Feeder Assembly, PN 12524100. NSN 1005-01-461-5038 for Enhanced Feeder Assembly, PN 12524100-1.

c. Preservation level (A) and date packed (MO/YR).

d. Serial number of feeder.

END OF WORK PACKAGE

UNIT

M242 25-MM AUTOMATIC GUN (NSN 1005-01-086-1400) M242 25-MM ENHANCED AUTOMATIC GUN (NSN 1005-01-454-0396)

PREPARATION FOR STORAGE OR SHIPMENT OF RECEIVER ASSEMBLY PRESERVATION OF RECEIVER ASSEMBLY - LEVEL A; MARKING OF BAGGED RECEIVER ASSEMBLY; INSTALLATION OF RECEIVER ASSEMBLY IN CONTAINER; MARKING OF EXTERIOR CONTAINER

INITIAL SETUP:

Tools and Special Tools

Goggles (item 19, WP 0085 00) Heat sealing machine (item 33, WP 0085 00) Marking stencil set (item 39, WP 0085 00) Strapping and sealing kit (item 40, WP 0085 00)

Materials/Parts

Black color lusterless enamel (item 8,

WP 0116 00) Black stencil ink (item 12, WP 0116 00) Corrosion inhibitor treated volatile paper

(item 16, WP 0116 00) Cushioning material (item 7, WP 0116 00) General lubricating oil (item 14, WP 0116 00) Interior packaging sleeve (item 24,

WP 0116 00) Pressure sensitive adhesive tape (item 29,

WP 0116 00) Pressure sensitive adhesive tape (item 30,

WP 0116 00) Sand color lusterless enamel (item 9,

WP 0116 00) Wiping rags (item 21, WP 0116 00)

Was this article helpful?

0 0

Post a comment