Note

The two round sleeve bushings look the same, but one bushing has a large inside bevel on the flanged end. The other has a smaller inside bevel.

2. INSTALL NEW ROUND, SMALL INSIDE-BEVEL SLEEVE BUSHING.

Apply sealing compound primer and adhesive to new round, small inside-bevel sleeve bushing (3) and install until bushing is seated into forward feed assembly (2).

ASSEMBLY - Continued

3. INSTALL NEW ROUND, LARGE INSIDE-BEVEL FLANGED SLEEVE BUSHING.

a. Turn over forward feed assembly (2).

b. Apply sealing compound primer and adhesive to new round, large inside-bevel flanged sleeve bushing (4) and install until bushing is seated into forward feed assembly (2).

4. INSTALL FORWARD FEED ASSEMBLY (WP 0034 00).

END OF WORK PACKAGE

UNIT

M242 25-MM AUTOMATIC GUN (NSN 1005-01-086-1400) M242 25-MM ENHANCED AUTOMATIC GUN (NSN 1005-01-454-0396)

FEEDER ASSEMBLY ROTOR REMOVAL/INSTALLATION REMOVAL, INSPECTION, LUBRICATION, INSTALLATION

INITIAL SETUP:

Tools and Special Tools

Artillery and turret mechanic's tool kit

(item 41, WP 0085 00) Turret mechanic's supplemental tool kit (item 44, WP 0085 00)

Materials/Parts

Acid brush (item 4, WP 0116 00) Grease (item 11, WP 0116)

References

WP 0007 00

Equipment Conditions

WP 0026 00 Automatic gun feeder removed WP 0027 00 Link bridges removed (Standard

Feeder only) WP 0028 00 Link cover assemblies removed

(Enhanced Feeder only) WP 0029 00 Link shield removed WP 0032 00 Ejection chute removed WP 0034 00 Forward feed assembly removed

Was this article helpful?

0 0

Post a comment