Note

The Enhanced Feeder must use PN 12524574 Forward Feed Assembly to accommodate the link cover assemblies. The Standard Feeder may use PN 12524273 or 12524574 with the link bridges.

REMOVAL

1. POSITION FEEDER DRIVE ASSEMBLY.

Place feeder drive assembly (1) on a clean, flat surface with feeder handle (2) down.

2. REMOVE CAPSCREW.

Remove capscrew (3) from lower right stepped spacer (4).

3. REMOVE SELF-LOCKING NUT.

Remove self-locking nut (5) from feeder standoff (6). Discard self-locking nut.

1df0281

4. POSITION FEEDER DRIVE ASSEMBLY.

Position feeder drive assembly (1) with lower feed sprocket assembly (7) up.

Was this article helpful?

0 0

Post a comment