Note

Labeled side of the volatile paper must be on the outside of the wrap.

a. Cut a section of volatile paper 36 in. (91.4 cm) wide by 42 in. (106.7 cm) long.

b. Wrap feeder with the paper. Fold paper over ends of feeder.

c. Secure paper wrap with tape (item 30, WP 0116 00).

d. Pad sharp projections with cushioning (8 pieces of 3 x 6). Hold cushioning in place with tape (item 30, WP 0116 00) (8 pieces of 2 x 10).

5. SEAL WRAPPED FEEDER IN INTERIOR PACKAGING SLEEVE.

a. Put wrapped feeder in 26 in. (66 cm) wide (seal-to-seal) by 36 in. (91.4 cm) long sleeve.

b. Using heat sealing machine, seal ends of sleeve.

c. Apply tape (item 29, WP 0116 00) around sleeve where sleeve contacts saddles (6 pieces of 2 x 10). MARKING OF BAGGED FEEDER ASSEMBLY

1. MARK SEALED SLEEVE (LEVEL A).

Was this article helpful?

0 0

Post a comment