Note

Check that bolt position indicator is in sear position.

AUTOMATIC GUN FEEDER MANUAL CYCLE CHECK - Continued with plastic-face hammer to loosen.

AUTOMATIC GUN FEEDER MANUAL CYCLE CHECK - Continued

with plastic-face hammer to loosen.

FEEDER DRIVE ASSEMBLY

FEED SHAFT STOP ASSEMBLIES

FEED SHAFT STOP ASSEMBLIES

ELECTRICAL FEED SELECT SOLENOID KNOB

FEEDER DRIVE ASSEMBLY

ELECTRICAL FEED SELECT SOLENOID KNOB

Place electrical feed select solenoid knob in upper feed (retracted) position. Observe upper feed shaft stop assembly and push timer release rod while turning worm shaft nut nine turns counterclockwise. Does feed shaft stop raise when you turn worm shaft nut and snap back in when automatic gun feeder locks in SEAR?

Repeat above steps in lower feed (extended) position and observe lower feed shaft stop assembly. Does feed shaft stop raise when you turn worm shaft nut and snap back in when automatic gun feeder locks in SEAR?

Feeder drive assembly is bad. Replace feeder assembly (WP 0026 00) and send defective feeder assembly to Direct Support Maintenance for repair.

WORM SHAFT NUT

TIMER RELEASE ROD

UPPER FEED AND LOWER FEED SPROCKET ASSEMBLIES

FEEDER ASSEMBLY ROTOR

WORM SHAFT NUT

TIMER RELEASE ROD

AUTOMATIC GUN FEEDER (BOTTOM VIEW)

AUTOMATIC GUN FEEDER MANUAL CYCLE CHECK - Continued

FEED SHAFT STOP ASSEMBLY

UPPER FEED SPROCKET ASSEMBLY

LOWER FEED SPROCKET ASSEMBLY

FEEDER DRIVE ASSEMBLY

FEED SHAFT STOP ASSEMBLY

FEEDER DRIVE ASSEMBLY

ELECTRICAL FEED SELECT SOLENOID KNOB
Reviews And Forward Feeder DiagramM242 Feeder
CARTRIDGE GUIDE

AUTOMATIC GUN FEEDER MANUAL CYCLE CHECK - Continued

Was this article helpful?

0 0

Post a comment