Note

If the worm shaft bevel gear sticks, tap lightly to loosen.

b. Pull worm shaft bevel gear (28) away from worm shaft (27).

M242 Index Drive

15. POSITION FEEDER HOUSING ASSEMBLY.

Place feeder housing assembly (1) on end as shown.

16. REMOVE WORM WHEEL GEAR.

Pull worm wheel gear (30) out of feeder housing assembly (1).

17. REMOVE TWO CAPSCREWS.

a. Place feeder housing assembly (1) on a clean, flat surface with feeder handle (4) in down position.

b. Remove two capscrews (31) that were temporarily installed in index drive cover assembly (32).

Was this article helpful?

0 0

Post a comment