Note

Packings are recessed under damper housing cap.

d. Remove preformed packings (11) and (12) from damper housing cap (10). Discard preformed packings.

e. Install headed straight pin (13) into hole in fluid pressure damper (14).

f. Using headed straight pin (13), lift straight up on fluid pressure damper (14) to break suction seal.

g. Remove fluid pressure damper (14).

h. Remove headed straight pin (13) from fluid pressure damper (14).

i. Remove damper housing assembly (1) from vise.

j. Drain off and discard any remaining damper fluid.

Was this article helpful?

0 0

Post a comment