Note

Spring segments and spacer must be kept dry during reservoir servicing.

Graphics are provided to show procedure being done with and without using damper rod tool.

a. Wrap three turns of a clean, dry wiping rag around recoil mechanism (1) above outer spring assortment segments (2) and recoil spring sleeve spacer (15). Secure rag with lockwire.

b. Slowly remove damper housing plug (3).

c. Remove and discard preformed packing (18).

d. Slowly fill damper reservoir with clean damper fluid until fluid is at top lower edge of filler hole e. Check that damper reservoir is full, and that no air bubbles can be seen in filler hole (19).

Damper Rod Removal Tool

1df0467

WITHOUT DAMPER ROD TOOL

WITH DAMPER ROD TOOL

1df0467

WITHOUT DAMPER ROD TOOL

WITH DAMPER ROD TOOL

Was this article helpful?

0 0

Post a comment