Note

The firing pin pawl and safety pawl must move freely when pressed. If binding occurs, both pawls should be removed, inspected, relubricated, and reinstalled.

f. Turn track (2) so that clevis assembly (3) is visible.

g. Install shorter helical spring (approximately 1-1/2 in. (38 mm)) (13) and detent pin (14) in track (2).

h. Place safety handle (15) on safety actuator (6). Seat detent pin (14) into detent (16) on bottom of safety handle (15).

i. Align spring pin holes in safety actuator (6) and safety handle (15). j. Install new spring pin (17).

k. Check safety handle (15) to ensure safety pawl (12) falls when bolt carrier assembly is put into FIRE position.

Was this article helpful?

0 0

Post a comment