Note

The following procedure is written for one feed shaft stop assembly, but applies to both feed shaft stop assemblies.

1. ASSEMBLE FEED SHAFT STOP ASSEMBLY.

a. Place feed shaft stop sleeve (1) in vise with large open end out.

b. Insert feed shaft stop button (2) into feed shaft stop sleeve (1).

d. Insert helical spring (5) in feed shaft stop button (2).

Helical Wound Spring

ASSEMBLY -Continued e. Check alignment of pin hole (3) with spring slot (4). Helical spring (5) should be visible in spring slot (4).

M242 Feeder

f. Start new spring pin (6) into pin hole (3). Check that feed shaft stop button moves in and out freely.

Was this article helpful?

0 0

Post a comment